HIWATT Custom DR504 50W Head

Toimitusaika: Pre-order, 30 päivä(ä)


HIWATT Custom DR504 50W Head

The little brother to the DR103, seen above, the Custom 50W Head is a design classic!

It has the same controls and features as the DR103, except it uses 2xEL34 in the power stage, providing a more than generous 50 watts RMS. It is lovingly hand built to the highest possible standards.

Switchable to 4, 8 and 16-ohm output impedance and with18-millimetre Baltic birch ply cabinet construction, this amplifier will last a lifetime!

— Normal and Bright channels with independent High and Low impedance inputs for each channel. Versatile and intuitive, perfect for bringing life out of dark pickups or taming shrill high end in bright pickups.
— Link the two channels for extra punch and dynamic control of your EQ via the independent channel volumes. Unleash the ’jumped’ channel sound Hiwatt is famous for.
— All the clean headroom you could want.


  • Wattage: 50W
  • Channels: Normal, Bright
  • Inputs: Normal Hi, Normal Low, Bright Hi, Bright Low
  • Output: 2 x 1/4" Speaker Out
  • Preamp Valves: 4 x ECC83 (12AX7)*
  • Output Valves: 2 x EL34 *Optionally replace one ECC83 for phase inverter with an ECC81 (12AT7)
  • Controls: Normal Volume, Bright Volume, 3-Band EQ shared by both channels — Bass, Treble, Middle Presence — Treble Boost shared by both channels, Master Volume, Standby — On/Off, Mains — On/Off
  • Voltage: Switchable using World Voltage Selector on the rear panel — 100V, 115V, 230V, or 240V
  • Impedance: Switchable using Impedance Selector on the rear panel — 4 Ω, 8 Ω, or 16 Ω Based on Hiwatt’s original circuit designed by Dave Reeves.
  • Original Partridge spec English transformers.
  • Meticulously hand-wired to Harry Joyce’s exacting military standards.
  • Proudly manufactured in our Custom Shop in Doncaster, England.
  • Road Ready — Rugged 18mm Birch-Ply Construction
  • Band Ready — ’Burned In’ and Tested by our Custom Shop Technicians
  • Touring Ready — World Voltage and Impedance Selectors
  • Height: 280mm (12")
  • Width: 630mm (25")
  • Depth: 280mm (12")
  • Weight: 19.15 kg (43 lbs)

Suitable speaker cabinets: SE212, SE412


Every DR504 is proudly handcrafted and built to order for you in our Custom Shop in Doncaster, England. Please allow up to 4 week lead time while your amplifier is being meticulously hand-wired.

Palaa kohteeseen Etusivu